Your home is fighting a Central Texas summer that runs hot and humid for months. Spray foam seals the leaks fiberglass leaves behind — so your AC stops running nonstop and your bills come down.
Most Waco homes were built with fiberglass batts in the attic and walls. Fiberglass slows heat, but it does almost nothing to stop air — and in a home, air leakage is where comfort and money escape. Hot, humid outdoor air pushes in through the attic, top plates, recessed lights, and wall penetrations while your cooled air leaks out. In our climate, that's a losing battle for eight months a year.
Spray foam changes the equation because it insulates and air-seals in one step. It expands to fill every gap and cavity, forming a continuous barrier against heat and infiltration. Homeowners typically notice three things: a lower summer electric bill, rooms that finally hold an even temperature, and an AC that cycles off instead of grinding all afternoon.
Where do we usually start? The attic. In a Central Texas home it's the single biggest source of heat gain and air leakage — and the highest-impact place to spray foam first.
Recognize a few of these? A free estimate tells you what sealing the envelope would do for your building.
We look at your attic, walls, and crawl space, note where air is leaking and where insulation is failing, and talk through your comfort and bill goals.
We recommend the foam that fits each area — usually open-cell for attics and interior walls, closed-cell where moisture resistance or tight space calls for it — and the thickness to hit your R-value target.
We mask and protect your home, and remove old or damaged insulation first if needed, so the foam bonds to a clean surface.
Our crew applies the foam, sealing the envelope continuously — attic deck or floor, wall cavities, rim joists, and penetrations.
We walk the finished work with you and explain how to get the most from your newly sealed home.
Here's the honest version of the payback question: spray foam isn't the cheapest insulation, but in a hot, humid, cooling-dominated climate like Waco's it targets the exact problem — air infiltration — that runs your bills up. The U.S. Department of Energy places Waco in Climate Zone 3A, where attic insulation around R-38 is the target; foam reaches that with less thickness than fiberglass and seals the leaks fiberglass ignores. We'll give you a realistic read on your home's savings during the free estimate rather than an inflated promise.
Tell us about your building. We'll measure, recommend the right foam and R-value, and put it in writing.
Both. We retrofit existing Waco homes all the time — most often by sealing and insulating the attic, and by removing tired old insulation first. New construction is easier to foam, but existing homes see some of the biggest comfort and bill improvements.
For most residential attics and interior walls, open-cell (~R-3.6/inch) is a cost-effective air seal. Closed-cell (~R-6 to R-7/inch) makes sense where you need moisture resistance or maximum R-value in limited space, like crawl spaces. We recommend per area — see our open-cell vs closed-cell page.
We'll advise on timing based on the areas being sprayed and ventilation. For many attic jobs you can stay; for larger interior work we'll give you clear re-occupancy guidance so it's done safely.
Done correctly, no — a properly designed sealed attic actually controls moisture better. In very tight homes we'll discuss ventilation or dehumidification so the house breathes right. Correct design is exactly what a professional install ensures.
R-value, climate-zone, and local weather figures cited above are drawn from public, authoritative sources so you can verify them independently.
Free estimate, honest foam recommendation, no pressure.
Get your free estimate